3m 724 esd monitor manual

Workstation Monitor Installation, Operation and Maintenance Description The SCS Workstation Monitor is intended to monitor the operation of two wrist strap grounding systems and Meets requirements of ANSI/ESD S and recommendations of ESD Handbook ESD TR Desco Industries Inc. - Company ProfileFile Size: 2MB. SCS (Formerly 3M Static Control) Workstation Monitor - Meets ANSI/ESD S Continuous Monitor required limits - Resistance (Dual-Wire) Wrist Strap and Worksurface Continuous Monitor per ESD TR Continuously monitors 2 operator dual-wire wrist straps and 1 worksurface mat - Visible and audible alarms indicate proper grounding of the operator and worksurface.

the Model monitor must be attached to separate electrical grounds. The work surface monitoring function is active any time that the power supply for the monitor is plugged in. Caution Disconnect the 3M D Monitor/ Table Mat Cord to prevent possible damage to the Model monitor before testing the resistance of the work surface with a. PAIR IT WITH. + $ Sierra FSWB 2-Layer Conductive Smooth Rubber Worktop Mat Kit, 30"x60"x", Blue. Satisfaction Guarantee. Free Gift. The SCS formerly 3M Continuous Work Station Monitor is intended to monitor the operation of two wrist strap grounding systems and two work surfaces. This product has been designed and tested for. SCS Monitor Verification Kit, Vk. The Verification Kit VK is designed to check the wrist strap input resistance ranges of the Workstation and Wrist Strap Monitors Series. Includes four 1% resistor plugs and case.

The Workstation Monitor is available in three models: Item Description Workstation Monitor, North America Power Adapter MO Workstation Monitor, No Power Adapter September USER GUIDE TB The following accessories are available for the Workstation Monitor: Item Description Verification Tester. The Plus Workstation Monitor features operator body voltage detection. It will alarm if the operator generates or comes in contact with voltage that would be dangerous to an ESD susceptible item. Each Plus Workstation Monitor is calibrated with accepted procedures and standards traceable to the National. Workstation Monitor ™ Figure 9 – Inserting 3M Dual Conductor Remote ™ Input Jack plug into rear of 3M Workstation Monitor ™ Page Selection Of Test Voltage And Resistance Limit Select the desired resistance and voltage limit by moving the appropriate slide switch (with screwdriver) on the side of the Workstation Monitor