How to manually vacuum swimming pool

 · Telescoping pole - www.doorway.ru Head (type depending on pool surface) - www.doorway.ru Hose - www.doorway.ru this video. 2 – Connecting Your Vacuum to the Pool Pump. The way a pool vacuum works is through your pool pump. The suction of your pool pump powers the vacuum and allows you to suck up the debris you’re targeting. This is a simple, and straight-forward process. All you need to do is connect the open end of your vacuum hose to the inlet of the pool www.doorway.ruted Reading Time: 4 mins. Vacuuming the Pool. Manually vacuuming your swimming pool takes a lot of work and time. Make sure you clear your schedule when you’re ready to do this. The shallow end is where you will begin, and then you gradually move to the deeper end. Your strokes should be slow and long as you’re sweeping them in the www.doorway.ruted Reading Time: 8 mins.

Submerge the vacuum head to the bottom of the pool. Hold the pole and extend it so it is long enough to reach the bottom. Push the vacuum head down slowly into the pool until it reaches the bottom. Start at the edge of the pool near a return jet, which is the jet that pushes water back into your pool after it gets filtered, so you can easily reach it with the hose. You probably assume that an automatic pool cleaner eliminates the need to have to manually vacuum an inground or above-ground swimming pool. Now it is true that the small robot device can clean some of the pool, but it has a tougher time cleaning large amounts of debris. Pool pros recommend pool cleaning at least once a week during the swimming season. You can use a manual vacuum or a time saving automatic pool cleaner to do the job. Or you can hire a pool pro to keep your pool in top condition. Of these three pool cleaning methods, a manual vacuum is the most economical but it requires the most time and energy.

Take the swivel end of your hose and attach to the vacuum head hose adapter. Take the vac head and stick it into the pool. Remove the skimmer lid. Now, before plugging the hose into the skimmer, we will need to flush the hose of any air to ensure the pool pump stays primed. A couple of ways to flush air from your vacuum hose. Telescoping pole - www.doorway.ru Head (type depending on pool surface) - www.doorway.ru Hose - www.doorway.ru this video. Step-by-step manual pool vacuuming guide. 1. Attach the vacuum head to the open end of the telescopic pole. 2. Take one end of the hose and attach it to the top of the vacuum head. Use a hose clamp if the hose tends to slip off frequently. 3. Place the vacuum head, pole and hose in the pool – all the way to the bottom so that the vacuum head.